Combilift Ltd C2500-C3000CB O&S Manual
4-6
C2500CB-OM-EN-11
4.2: Operators Daily Inspection Sheet
Damage
Bent, Dented or Broken Parts
Leaks
Tank, Valves, Fittings, Hoses
Tires
Chunks missing, Loose wheel nuts
Forks
Bent, Damaged or Worn
Mast (inc. Chains)
Damage, Signs of bending, loose chains
Overhead Guard
Damage, Cracking
Engine
Smell, Belts tight and in good condition
Engine Oil Level
Signs of damage or leaking
Coolant level
Acceptable Range
Hydraulic Oil Level
Acceptable Range
Radiator & Oil Cooler
Build up of leaves, dust or debris
Hoses
Good Condition, No signs of wear
Safety Equipment
Horn, Operator Restraint, Reversing Bleeper
Engine
Starts and runs OK, no unusual noise
Mode change
Wheels realign smoothly, no sticking
Travel
No unusual Noise, Smooth changes
Steering
No excessive play or restriction in either mode
Inching Pedal
Stops travel, smooth deceleration
Parking Brake
Functions and releases
Hydraulic Controls
Forks-Lift/lower, mast-in/out, tilt, Aux functions
Hour Meter Reading
Operator Initials
Supervisors Initials
OKOK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
Operational Checks
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OK
OK
OK OK OK OK
OK OKOK OKOK OK
OK OKOK OK
Fri Sat Sun
Visual Checks
OK OK OK
Mon Tues Wed Thurs
Operators Dail
Inspection Sheet
Model: Serial No:
Date: Shift No:
Inspect the Combilift before each shift. Should the Combilift be found to require servicing or if during the
operation the Combilift malfunctions or becomes unsafe, stop the truck and report the situation immediately to
the designated authority. DO NOT operate the Combilift or attempt to service it. Servicing is only to be
conducted b
a
ualified technician.
Mark the Appropriate Box with
X
OK
Machine OK
Service Required
Notes (regarding repair, etc):