CombiLift C3000CB - Page 30

Combilift Ltd C2500-C3000CB O&S Manual
4-8
C2500CB-OM-EN-11
Recommended Engine Oil Specification:
Diesel: API – CF (If a diesel particulate filter (DPF) is fitted See 4.13:)
SAE 15W40 – All Temperatures
SAE 10W30 – All Temperatures
LPG: API – SJ/CF
SAE 10W30 – All Temperatures
SAE 15W40 – Above -18°C (0°F)
In order to change the Oil and filter the following steps should be taken:
 Position a suitable container beneath the Oil drain plug. (Container must
be capable of holding 7 litres / 1.85 US Gallons)
 Remove the oil filler cap from the top of the engine.
 Remove the drain plug (attach the drain hose provided – if applicable) and
allow the system time to drain completely
 Once the system has drained completely, dispose of the used oil in a safe
and responsible manner
 Remove the engine oil filter located on the side of the engine.
 Apply some engine oil to the new oil filter cartridge before fitting.
 Install the new engine oil filter cartridge, ensuring that the O-ring seal is
correctly placed. Hand-tighten the filter, then give it an additional ½ turn
with a filter wrench.
 Reinstall the drain plug and tighten appropriately (Use a new gasket if
required).
 Fill the engine with the appropriate volume of oil ensuring that the oil with
the correct temperature range is used. The Volume of oil required is:
 Kubota Diesel Engine: 6.7 Litres / 1.77 US Gallons
 GM LPG Engine: 4.7 Litres / 1.24 US Gallons
 Toyota 4Y LPG Engine: 4.0 Litres / 1.1 US Gallons
 Reinstall the filler cap. Check the oil level on the dipstick. Ensure that the
oil level is between the upper and lower marks on the dipstick.
Note
Do not pour fluids into the ground, down a drain or into a stream, pond or
lake. Observe relevant environmental protection regulations when disposing
of oil, coolant, fuel, electrol
y
te and other harmful waste.