Safety Information
9
C3M2-OM-EN-02
Caution
The warning devices are installed to protect the life of the operator and
those working in the vicinity of the truck. Do not remove or bypass any of
the warning devices.
Combilift will not assume liability for injuries or damages arising from or
caused by the removal or bypassing of any the trucks warning devices.
Seat Switch
The purpose of the seat switch is to prevent the truck from being operated from an
incorrect position. When the seat is unoccupied the drive is disabled and the
hydraulic function levers are locked (the hydraulic joystick – if fitted – is blocked).
The following safety devices may be fitted as optional extras:
Seat Belt Switch
The purpose of the optional seat belt switch is to encourage the operator to wear the
seatbelt. The seatbelt should always be fastened across the top of the lap when
driving the truck. If fitted, the truck will not drive unless the seat belt is buckled.
Mast Above Height Drive Cut-out
This optional safety feature disables the drive when the forks are raised above a
predetermined height. This helps to avoid collisions between the mast and potential
overhead obstructions. To enable the drive, lower the mast below the cut-out height
or press and hold the cut-out override button.
Mast Lift Cut-out
This optional safety feature cuts out the lift function when the forks reach a
predetermined height. This helps to avoid collisions between the mast and potential
overhead obstructions. To continue raising the mast press and hold the lift cut-out
override button whilst operating the control lever.
Mast Not Fully Retracted Drive Cut-out (If Fitted)
This optional safety feature disables the drive if the mast reach function is not fully
retracted. This helps to avoid collisions between the forks and potential obstructions.
To enable the drive, retract the mast reach fully.
Inch Brake Pedal Brake Switch
The inch brake pedal brake switch applies the park brake when the inch brake pedal
is depressed and held in for 3 seconds or more. This safety feature brings the truck
to a complete stop.
1.5 Warning Devices
Warning devices are installed to make individuals in the vicinity of the truck aware of
its presence while it is being operated. The warning devices must be checked
frequently as part of the pre-use inspection and maintained in good working
condition at all times.
To Next Page
Loading...
