EasyManua.ls Logo

CombiLift C5000 - Starting the Engine

Default Icon
150 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
74
C3M2-OM-EN-02
Warning
The ‘Basic Information’ section of this manual contains crucial information
on topics such as ‘centre of gravity’ and ‘rated capacity’ that must be read
and understood prior to operating the truck.
Warning
Before starting the engine ensure that bonnet is closed and that there are no
bystanders in the immediate vicinity of the truck.
Never allow the engine to run in an enclosed area. Engine exhaust fumes are
harmful. Do not inhale exhaust.
5.8 Entering and Exiting the Operator’s Cabin
When mounting or dismounting the truck three points must be kept in constant contact
with the truck. That means one hand and two feet, or two hands and one foot – at all
times. Anything less and the risk of a fall is increased. Handgrips and footsteps have
been provided to allow easy and safe access to the operating enclosure. DO NOT use
the steering wheel as a handgrip.
When entering or exiting the operator’s cabin:
Check that the handgrips and footsteps are clean and in
good condition before using.
Always face in towards the machine and use the handgrips
and footsteps provided.
Mount and dismount only when the truck is stopped.
Break three-point contact only when you reach the ground
or cabin.
Take extra care in wet or frigid conditions.
Avoid wearing loose or torn clothing that can catch on the
truck.
NEVER JUMP!
5.9 Starting the Engine
#
Note
The truck will NOT start unless:
The four-way direction switch is in the neutral position
The battery isolator switch is in the ‘ON’ position
The operator is sitting on the seat
The seat belt is fastened *
* only if optional seat belt switch is fitted

Table of Contents

Related product manuals