Maintenance
117
C3M2-OM-EN-02
Note
Clean and dry the area around the filter housing thoroughly. Contamination
must be avoided. Block off the engine air intake if necessary.
Air contaminated with dust entering the engine will cause damage and
reduce performance.
Never run the engine if parts of the air intake system are removed. Replace
damaged air filter system parts immediately.
To Service the Air Filter
1. Stop the truck in a designated service
area.
2. Lower the forks fully then tilt the mast
forward fully.
3. Turn the ignition key switch to the ā0ā
position, then remove the ignition key.
4. Open the bonnet (A) from the rear of
the truck to gain access to the air filter
(B).
5. Inspect the air intake hose for cracks or
other damage and repair or replace as
necessary. Inspect all connections and
clamps and ensure they are tightly
sealed. Any leaks here will admit dust
directly to the engine.
6. Check the outlet slot on the dust valve
(C) for dust build up. Remove dust by
pinching the valve. Make sure the dust
valve is flexible and not inverted,
damaged or plugged. Replace the
dust valve if necessary.
7. Unlatch the filter cover (D) and
remove from the filter housing (E).
D
E
F
C
G
B
Kubota WG2503 LPG
Kubota V1505 Diesel
B
A
To Next Page
Loading...
