Comelit 3360B - Enabling;Disabling the Welcome Message; Entering the Welcome Message

1616
This function is disabled by default.
It is possible to enter the welcome message using software
Art. 1249B.
1. access programming mode, see page 6
2. select the menu items:
` Settings ⇒ Welcome message ⇒ Change
8. Entering the welcome message
CHANGE
ENABLE
STATIC MESSAGE
OK OK
SCROLL ESC
WELCOME
SCROLL OK
ESC CANC
PARAMETER
CHANGED
3. press or to conrm
4. enter the welcome message using the alphanumeric
keypad, for the use of special characters see table on
page 3
5. press or to conrm
6. to exit, press
7. Enabling/disabling the welcome message
This function can be used to enter a welcome message
(MAX 40 characters long, covering 4 lines in block capitals).
The welcome message alternates with the normal
information screens every 4 seconds.
N.B.: the message cannot be switched to the second
language when the SECOND LANGUAGE function is on
(see “3. Setting the second language" page 12).
1. access programming mode, see page 6
2. select the menu items:
Settings ⇒ Welcome message ⇒ Enable
NAME ONLY
YES
*NO
OK OK
SCROLL ESC
CHANGE
ENABLE
STATIC MESSAGE
OK OK
SCROLL ESC
WELCOME MESSAGE
YES
*NO
OK OK
SCROLL ESC
3. press or to conrm
4. select YES to enable the function, NO to disable it
5. press or to conrm
» * indicates active selection
4. select YES to enable the function, NO to disable it
5. press or to conrm
» * indicates active selection