Appendix IV Prompt Information
Prompt information appears in the using of this electrocardiograph is as shown in the following table
Prompt Information and Causes
Electrodes fall off from the patient or the patient cable falls off from the unit.
The built-in battery is low battery.
ECG signal is being sampled/ printed.
The ECG data is ready to be recalled.
The ECG data is being processed.
No more patient cases can be saved in “RECALL” interface.
There is no paper loaded or it is used up.
The USB printer is not connected or is not connected properly.
There is no paper loaded in the USB printer or it is used up.
the “Printer Select” is set as “Close”.
The electrodes are not connected correctly.
To Next Page
