Improper operation may cause the battery to be hot, ignited or exploded or it may lead to the
declination of the battery’s capacity. It is necessary to read the user manual carefully and the
warnings and cautions before using of the rechargeable lithium battery (hereinafter called
“Battery”).
Do not reverse the anode and cathode when connecting the battery, otherwise explosion may be
caused.
Do not use the battery near the fire source or in the environment with temperature higher than
45℃. Do not heat the battery or throw it into the fire. Avoid the battery to be splashed by water
and do not the throw the battery into water.
Do not penetrate the battery with metal, hammer or beat the battery or use other methods to
damage the battery, otherwise battery heating, smoking, distortion or burning may be caused and
risk occurs.
When leakage or foul smell is found, keep far away from the battery immediately. If your skin or
clothes comes into contact with the leakage electrolyte, rinse it with clean water at once. If the
electrolyte splashes into your eyes, do not rub them. You should irrigate them with clean water
first and go to see a doctor immediately.
Only authorized installation or maintenance engineer can open the battery compartment and
replace the battery; and the rechargeable lithium battery of the same mode provided by Comen
Company should be used.
When the service life of the battery is over, or there is peculiar smell, deformation, discoloration or
distortion, the battery should be stopped to use immediately and disposed of the battery according
to the local regulations.
Turn off the power before the cleaning. If the AC power supply is used, the AC power supply
should be cut off and the power cord and patient cable should be removed.
Pay attention not to prevent the liquid from entering the inner of the equipment. Do not immerse
the equipment and patient cable into the liquid in any case.
It is prohibited to use abrasive material to conduct cleaning and avoid scratching the electrodes.
Any residual detergent in the instruments and on the surface of the patient cable should be avoided
after cleaning.
To Next Page
