Operation Preparation
3-4
2) Unwrap the new folded record paper and place it into the paper tray. Pay
attention to that when the free end of the record paper is vertical, the grid
surface of the record paper should face the thermosensitive print head;
3) Pull about 2cm of paper out from the paper exit and close recorder cover.
4) Select [Config.]→[Print Settings]→[Paper Style]→[Folded]
3.3 Connect ECG Cable
Figure 3-2 ECG cable
ECG cable includes two parts: main cable which is connected to the
electrocardiograph and the lead wires which are connected to the patient. Lead
wires have 6 chest lead wires and 4 limb lead wires. The user can distinguish the
chest leads and limb leads from the color of the lead wires and the identifiers on
the connector.
ECG Cable Connection: Plug the ECG cable into the ECG cable socket on the
right panel of the electrocardiograph; secure the screws at the two sides of the
plug.
To Next Page
Loading...
