H3 meets the requirement of electromagnetic compatibility in
IEC60601-1-2.
H3 meets the requirement of Group I Class A in CISPR 11/EN 55011.
The user needs to install and use according to electromagnetism
compatibility information which is attached with it.
Portable and mobile RF communication devices may influence H3
performance, so H3 should be kept away from them during using.
Guidance and manufacturer’s declaration stated in the appendix.
H3 should not be used adjacent to or stacked with other equipment
and that if adjacent or stacked use is necessary, the H3 should be
observed to verify normal operation in the configuration in which it
will be used.
Class A equipment is intended for use in an industrial environment.
The H3 may be potential difficulties in ensuring electromagnetic
compatibility in other environments, due to conducted as well as
radiated disturbances.
To Next Page
Loading...
