Comen H3 - System Settings; Patient Information

System Settings
4-3
determined by the settings of [Rhythm Lead 1], [Rhythm Lead 2], [Rhythm Lead 3]
and [Rhythm Lead Type].
Specific operation steps:
1) Click Auto/ Manual/ Rhythm mode hotkey to switch to Rhythm mode;
2) Press key to sample ECG waveform automatically and [Sampling]
prompt message will appear in the prompt message area. After sampling, ECG
waveforms will be printed until the printing ends automatically.
Note
 The ECG waveform and data will not be saved as patient case under
rhythm mode.
 When [Print Select] is [Internal], [Rhythm Lead Style] can only be set as
[1 Channel], when [Print Select] is [External] and [close], [Rhythm Lead
Style] can be set as [1 Channel] and [3 Channel].
4.5 System Settings
4.5.1 Patient Information
Click [Config.] to enter the setting screen select [Patient Info], shown as the
following figure: