23
The load support system and the external surface of the sterilizer are sometimes protected
by a plastic film: it must be removed before using the sterilizer.
Storage
If the sterilizer will not be used immediately or if will be removed from the installation site, it
must be stored in a dry, protected location.
If you wish to cover the sterilizer with plastic sheeting, you must first insert silica gel or other
desiccant systems inside the packaging.
Ideal ambient storage conditions are:
- temperature with empty systems - 25°C + 40°C.
- maximum relative humidity 90%.
Never place any objects on top of the sterilizer packaging, especially with loads
concentrated on protruding feet or screws.
!
Transportation and packaging
To Next Page
Loading...
