36
Press ENTER to return to STAND BY mode. The display will indicate which start is
programmed:
At the set time, the sterilizer will automatically run the chosen cycle.
Press CANCEL to cancel the programmed start and return to STAND BY.
3.3 Hollow Loads
This function allows for automatic recognition of the load type (HOLLOW A, HOLLOW B, or
SOLID), entering the length and diameter of the cavity (in millimetres) and the number of
open ends.
Press ENTER to display the value of the first item:
Use the ↑↓ arrows to change this value. Press ENTER to confirm the information and move
to the next item.
Operation
To Next Page
Loading...
