Commodore PC 40 - Page 348

1210 MS-DOS User's Reference
Debug command
A [address]
C range address
D [range]
E address [list]
F range list
G [=address [address ... ]]
H value value
I value
L [address [drive:record record]]
M range address
N filename f/ilename]
o value byte
Q
R [register-name]
S range list
T [ = address] [value]
U [range]
W [address [drive:record record]]
Function
Assemble
Compare
Dump
Enter
Fill
Go
Hex
Input
Load
Move
Name
Output
Quit
Register
Search
Trace
Unassemble
Write
How to use the Debug Debug Command Parameters
command parameters
All debug commands accept parameters, except the Q (quit)
command. Parameters may be separated by delimiters (spaces or
commas), but a delimiter is required only between two consecu-
tive hexadecimal values. Thus, the following commands are
equivalent:
dcs:100 110
d cs:100 110
d,cs:100,110
[=