EasyManua.ls Logo

CommScope SURFboard SBV3202 - Basic battery installation and replacement

CommScope SURFboard SBV3202
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2: Battery installation and removal
Maximum backup battery: provides up to 18 hours (6-cell) or 24 hours (8-cell) of backup
time, depending on model and usage. It replaces the battery door and increases the
height of your telephony modem by about 5/8" (16 mm).
Maximum backup battery
Refer to Maximum battery installation and replacement (page 20).
Note: The backup times shown here are only an estimate and assume that your
battery is fully charged. If your battery is partially discharged (for example, if it is
in the middle of a self-test or is not yet fully charged), then your backup time will
be reduced.
Basic battery installation and replacement
Your telephony modem provides continued telephone service during power outages. The
battery backup is not intended to take the place of AC power.
To install and replace the backup battery.
1. Press down and pull back on the latch holding the battery door (on the bottom of your
telephony modem ). Pull the door toward you. Set the door aside in a safe place.
1 - Latch End
CAUTION: Risk of equipment damage Improperly inserting the battery may
damage the battery connector in your telephony modem. Carefully follow the
instructions in the next step to avoid damage.
2. Hold the battery pack so that the guides on the battery align with the slots on your
telephony modem and slide the battery into the bay.
SURFboard
®
SBV3202 DOCSIS 3.0 telephony modem for Xfinity
®
customers User Guide STANDARD Revision x.3 17

Related product manuals