CommScope SURFboard SBV3202 - Reset button and battery boot

Chapter 4: Using the telephony modem
Power, US/DS,
Online
Telephone 1 Telephone 2 Description
Normal Operation
Cable modem startup sequence
DS/US Online Description
Flash Off Downstream or upstream search
On Flash Downstream and upstream found;
retrieving setup information from service provider
On On Ready for service
Using the Reset button
Use the Reset button, on the back of your telephony modem, to reset the modem and
perform initialization as if you power cycled the unit. You may need to reset your telephony
modem if you are having problems connecting to the Internet. Using this button will be rare.
Use a pointed non-metallic object to press this button. The Reset button is recessed to
prevent accidental resets.
Booting from the battery
Your telephony modem supports a "Boot from Battery" feature that allows to provide a
continued telephone service during power outages.
To start your telephony modem from its battery, follow these steps:
1. If a battery is already installed in your telephony modem, remove it.
2. Re-insert the battery into your telephony modem. See Battery installation and removal
(page 16) for details.
3. Press the Reset button; the Power light should turn on immediately.
Note: If your telephony modem does not turn on, the battery may not be
charged.
SURFboard
®
SBV3202 DOCSIS 3.0 telephony modem for Xfinity
®
customers User Guide STANDARD Revision x.3 31