Comnet CNGE2FE8MSPOE - Spanning Tree Commands Set

137
[PortNumber]
trunk-link tag
[TaggedVID List]
VLAN by trunk group
trunk-link tag 2,3,6,99
or
switch(vlan)#vlan 8021q trunk 3
trunk-link tag 3-20
vlan 8021q trunk
[PortNumber]
hybrid-link untag
[UntaggedVID]
tag
[TaggedVID List]
V
Assign a hybrid link for
VLAN by trunk group
switch(vlan)#vlan 8021q trunk 3
hybrid-link untag 4 tag 3,6,8
or
switch(vlan)#vlan 8021q trunk 3
hybrid-link untag 5 tag 6-8
show vlan [GroupID]
or
show vlan
V
Show VLAN
information
switch(vlan)#show vlan 23
no vlan group
[GroupID]
V
Delete port base
group ID
switch(vlan)#no vlan group 2
Spanning Tree Commands Set
Netstar Commands
Level
Description
Example
spanning-tree enable
G
Enable spanning tree
switch(config)#spanning-tree
enable
spanning-tree priority
[0~61440]
G
Configure spanning
tree priority parameter
switch(config)#spanning-tree
priority 32768
spanning-tree max-age
[seconds]
G
Use the spanning-tree
max-age global
configuration
command to change
the interval between
messages the
spanning tree receives
from the root switch. If
a switch does not
receive a bridge
switch(config)#spanning-tree
max-age 15