72
6.15.3 State Activity
Having set up the LACP aggregator on the tab of Aggregator Setting, you can configure the
state activity for the members of the LACP trunk group. You can tick or cancel the checkbox
beside the state label. When you remove the tick mark of the port and click , the
port state activity will change to Passive.
Active: The port automatically sends LACP protocol packets.
Passive: The port does not automatically send LACP protocol packets, and responds
only if it receives LACP protocol packets from the opposite device.
A link having two passive LACP nodes will not perform dynamic LACP
trunk because both ports are waiting for an LACP protocol packet from
the opposite device.
To Next Page
Loading...
