Comnet CNGE2FE8MSPOE - Commands Set

146
port of monitor
function
monitor tx [Port ID]
G
Set TX destination
port of monitor
function
switch(config)#monitor tx 3
show monitor
P
Show port monitor
information
switch#show monitor
show monitor
I
Show port monitor
information
switch(config)#interface
fastEthernet 2
switch(config-if)#show monitor
no monitor
I
Disable source port of
monitor function
switch(config)#interface
fastEthernet 2
switch(config-if)#no monitor
802.1x Commands Set
Netstar Commands
Level
Description
Example
8021x enable
G
Use the 802.1x global
configuration
command to enable
802.1x protocols.
Switch(config)# 8021x enable
8021x system radiusip
[IP address]
G
Use the 802.1x
system radius IP
global configuration
command to change
the radius server IP.
Switch(config)# 8021x system
radiusip 192.168.1.1
8021x system serverport
[port ID]
G
Use the 802.1x
system server port
global configuration
command to change
the radius server port
switch(config)# 8021x system
serverport 1812