Comnet CNGE2FE8MSPOE - Port Mirroring Commands Set

145
[User Name]
user of SNMPv3
agent.
Test
no snmpv3 access
context-name [Context
Name ]
group
[Group Name ]
security-level
[NoAuthNoPriv|AuthNoP
riv|AuthPriv]
match-rule
[Exact|Prifix]
views
[Read View Name]
[Write View Name]
[Notify View Name]
G
Remove specified
access table of
SNMPv3 agent.
Switch(config)#no snmpv3
access context-name Test group
G1 security-level AuthPr
iv match-rule Exact views V1 V1
V1
no snmpv3 mibview
view
[View Name]
type
[Excluded|Included]
sub-oid
[OID]
G
Remove specified
mibview table of
SNMPV3 agent.
Switch(config)#no snmpv3
mibview view V1 type Excluded
sub-oid 1.3.6.1
Port Mirroring Commands Set
Netstar Commands
Level
Description
Example
monitor
[RX|TX|Both]
I
Configure source port
of monitor function
switch(config)#interface
fastEthernet 2
switch(config-if)#monitor RX
monitor rx [Port ID]
G
Set RX destination
switch(config)#monitor rx 2