COMPRO IP70 - Reset to the Factory Default Settings

9-2 Reset to the Factory Default Settings
Compro IP55 / 60 / 70 Network Camera
Reset to the Factory Default Settings
If you forget your system password or if you feel your IP camera has been acting weird, you can follow the
steps below to reset the camera to its default state in which it will be using the Ethernet port for network
connection and obtaining IP from the available local DHCP server. To reset the camera:
1. Pressandholdtheresetbutton(locatedattherearpanel)forabout10seconds;whensuccessful,you
shall see the Status Indicator go o.
2. After about 5 more seconds, the Status Indicator comes on again. It means that the IP camera has
been successfully reset and restored to the factory default settings.
3. Re-congure the Compro IP camera using the iWizard.
Once the camera is reset, it will take 1 minute to reboot. Please wait and start the iWizard later again to scan
for the camera.
Reset Button
Figure 9-2. Reset button