(2) Installation
●Power Source
1) Use a power source with a stable voltage.
2) Use a power source which is independent from other equipment.
●Installation
Avoiding installing the machine in any of the following places:
1) Subject to high humidity and dust.
2) Exposed to strong or continuous vibrations.
3) Exposed to direct sunlight.
“CAUTION”: DISCONNECT POWER SUPPLY CORD BEFORE
OPENING HOUSING.
“WARNING”: EXPLOSING HAZARD - DO NOT USE
NON-RECHARGABLE BATTERIES.
(3) Wall Mounting
1) Place 2 screws into a wall 3.94 inches (10cm) apart. Be sure to keep
approx. 0.12 inch (3mm) of the screw head protruding from the wall.
2) Hook the unit on to the screws through the holes of the back cover, as
shown in the figure.
* Please note position of security hole (located above the left fixing hole).
Installation: Remove lid, mark position of hole onto the wall, remove
machine, drill, fit wall plug, refit machine to wall, enter security screw into
position and replace lid.
4
TO PLACE AN ORDER CALL: 866-487-4751
OR VISIT: WWW.TIMECLOCKEXPERTS.COM
To Next Page
Loading...
