Contents XPS/XPS-E User's Manual
2 ļ COMSOFT
2 Setting into Operation
When developing the XPS products, COMSOFT put great stress on an easy
installation. Following this aim, no external devices, e.g. configuration tools on
a PC are required to execute the configuration. All connections are realised by
D-SUB connectors, power plug (EN 60320) or spring clip terminals which can
all be accessed and loosened easily. The PROFIBUS station address is set via
coding switches. All further settings are done via UserParameter of the
SetParam telegram of PROFIBUS-DP. This parameterisation is executed,
simplified by the deliverable GSD file either via the configuration tool of the
connected PROFIBUS-DP Master or by the user program.
To Next Page
Loading...