Conair 200 - Page 46

4-10 l Operation
Screen
Screens 15-27 require access
code 754.
SCREEN 20 (Set up Screen)
MDC Option (Models 150 & 200
only)
SCREEN 21 (Set up Screen)
Regeneration Differential
Temperature
SCREEN 22 (Set up Screen)
Regeneration Outlet temperature
Function
Control Function Descriptions
(continued)
This screen shows the time delay setting
for the conveying blower on the MDC.
This is the minimum time the MDC will
wait before starting another load cycle.
This screen shows the differential tempera-
ture at the regeneration inlet and the outlet
at the desiccant wheel. If the actual tem-
perature is under the set value, the dryer
will alarm (P31), but will still run.
This screen is the actual temperature meas-
ured at the regeneration outlet on the
wheel.
20
C07
C
200
C08
C
10
C06
C
Control function only
available for MDC only.