Tip: PPPoE dial-up successful, according to 【 PPPoE IP
】
shown on IP address, users can remote access
hard disk video recorder by IP access.
The DVR support model：
Unicom：Huawei E173,ZTE MF100
Telecom:huawei EC150.huawei EC156.ZTE MF583
“3G DIAL” have two modes with automatic and manual dialing, the operation follows as below.
1. Automatic Dialing
Select the Automatic Dialing mode in the interface of the following picture, fill the right information according to
the operator where the 3G card belongs to and the 3G referred guide, It includes IPS names, AP, dial-telephone, ID
and password, the interface shows as the other following picture (some IPS once be chosen, the other relative
information has been already done, so you needn’t fill any more, click “SAVE” directly). Then click “Save” directly.
After having detected the 3G signal when DVR start, the system will dial up automatically.
2. Manual Dialing
In the interface of following picture, users would fill the right information in the menu bar as same as
Automatic dialing and click “SAVE”. Then click “Dial-up” after saving successfully (The referred information
would be saved still after the DVR restart, but you should click “Dial-up” again).
In these two modes, if the dial-up want success, first you should make sure that the 3G card is available. Since
the 3G signal has been existed, the related menu bar will show the correct IP address; if failed, system will popup a
window to show the incorrect information.
(3)DDNS Setup
To Next Page
Loading...
