Pressing the left mouse key, drag the mouse to select a Motion detection
area, then press the right mouse key and drag to cancel the selected area.
Dragging playback Progress Bar back and forth to dolly moves, to achieve the
playback position adjustment. Dragging the audio and video regulation
parameter bar dolly moves, to achieve the parameter adjustment.
3.2 Powering On
Boot-
strap
If【POWER】pilot lamp is off, please follow these operations step by step:
First step: if the power is not plugged in, please plug in the power, then the DVR should start. If the
DVR remains inactive, move on to the next step.
Second step: turn on the power supply of the DVR at the back panel, and the DVR
should start.
If【POWER】pilot lamp is RED, press the 【POWER】key, DVR should start.
The video output mode of the DVR defaults to multi picture channel mode after starting the DVR. If at the
time of starting the DVR the video output mode is in the Timing Recording setting, the DVR will automatically
start the Timer Recording function, and the corresponding channel’s recording pilot lamp will be lit up. The DVR
will function as normal.
To Next Page
Loading...
