ConMed ExcaliburPLUS PC - Explanation of Symbols; Control Panel Symbols; Output Panel Symbols; Top Cover Symbols

MI rrrr_r_r_—__r_._._.._.._
1.3 EXPLANATION OF SYMBOLS
+
|
トキ
vr
hg
OD
Sede
CONTROL PANEL
Pure Cut waveform with minimum
thermal damage and hemostasis
Blend 1-Cut waveform with moderate
hemostasis
Blend 2-Cut waveform with heavy
hemostasis
Blend 3-Cut waveform with maximum
hemostasis
Standard Monopolar Coagulation
Spray Monopolar Coagulation
Return Fault Alarm - Monopolar output
is disabled
Return Electrode Monitor set
Resis
ative resistance of return electrode
contact with the patient
Single Pad - Used with electrodes that do
not monitor contact quality
Dual Pad - Sets monitor to use electrodes
that do monitor contact quality
Bipolar Coagulation
Bipolar Cut
Program
Program Store
Remote Power Control
INTERIOR
Replace Fuse only with type and rating
as shown
Protective Earth (Inlet Connector)
High Voltage Circuitry
nce - In Dual Pad mode, indicates rel-
DP
Pasai-
|
IPX1
OUTPUT PANEL
Handswitched Output - Connection for
handswitched monopolar accessories
Footswitched Output - Connection for
footswitched monopolar accessories
High Voltage Outputs
Bipolar Output - Connection for bipolar
accessories
Handswitched Bipolar Output
Footswitched Bipolar Output
Type CF - Patient connections are isolated
from earth and resist the effects of difibrilla-
tor discharge
Return Electrode - Connection for monopo-
lar dispersive electrode
RF Isolated - Patient connections are isolat-
ed from earth at high frequency
Consult accompanying documents prior to
placing equipment in service
TOP COVER
Consult accompanying documents prior to
placing equipment in service
CAUTION - High Voltage Inside - Refer
servicing to qualified personnel
Explosion risk if used with flammable anes-
thetics
This equipment intentionally supplies non-
ionizing RF energy for physiological effect
Enclosure resists entry of vertically falling
water
REAR PANEL
Equipotential Ground Stud
Footswitch Connector