ConMed ExcaliburPLUS PC - ACC and ERR Fault Code Information; Environmental Protection Guidelines

ec
2.7.2 ACC Faults
ACC Codes are most often caused by faults in
accessories attached to the unit. Often the fault
can be corrected in the operating room without a
service call. The following list gives the meaning
of each code, and what to check. For each code,
check to see that the switch, panel or accessory is
not being pressed while the unit is powering up.
Turn unit off, unplug accessory, then turn unit
back on. If the code still shows, call service.
ACC
Code What to check
FS Monopolar Foot Switch shorted
(Ensure Foot Switch treadle is not
depressed.)
LH Left Hand monopolar accessory shorted
tH right Hand monopolar accessory shorted
bP biPolar accessory shorted
*CPxx Control Panel key stuck
*Note: “xx” displayed in the bipolar window cor-
responds to the stuck key using figure 2.1 as a
reference. Multiple keys show as “88”.
2.7.3 Err Faults
Err Code faults generally cannot be corrected in
the operating room and require a repair techni-
cian. Occasionally, turning the unit off and back
on will clear an Err fault and resume normal
operation of the unit.
2.7.4 If All Else Fails
Contact CONMED Corporation Technical
Services at the phone or fax numbers listed on the
inside front cover of this manual. Please have the
model and serial numbers from the rear panel
nameplate along with a description of the prob-
lem, including power settings, accessories in use,
and fault code.
2.8 ENVIRONMENTAL PROTECTION
The shipping container and packing material
should be retained in the event the unit must be
returned for factory service. At the end of the
equipment’s life, it should be disposed of in
accordance with your local regulations.
Component materials are:
* Aluminum enclosure and heatsinks.
+ Unit front handle is steel.
* Thermoset printed wiring boards containing
miscellaneous electronic components.
* Power transformer made of steel and copper.
* Mains cord made of thermoplastic and copper.
* Shipping container is cardboard; packing mate-
rials are a combination of Urethane foam and
Polyethylene film.