SRT X-BAND RADAR SYSTEMS
WARNINGS
304202P003 3 Rev. C
CAUTION
IF THIS IS OPERATING PROCEDURE, MAINTENANCE
PROCEDURE, PRACTICE, CONDITION OR STATEMENT IS
NOT STRICTLY FOLLOWED, COULD RESULT IN INJURY OF
PERSONNEL OR PROPERTY DAMAGE .
NOTE
Advice of an essential operating procedure, maintenance
procedure, condition or statement which must be followed.
Whenever a precaution, relating specific part of the technical manual is needed,
precaution information is given in the relevant part of the manual. Warnings and
Cautions Signs precede applicable text.
Safety Operations
During normal operation (front cover closed), the unit can be quickly
disconnected from the main power line, setting to OFF the main circuit breaker
located on the electric switchboard.
During maintenance (front cover opened), it is possible to turn on the unit, by
linking P1 on SRT Power Board (Chapter 9, Figure 9.1.10, pos. 5).
This link forces the unit main power to be ON. During normal operation P1 on
SRT Power Board must be set OPEN.
NOTE
The main power line is always present on the terminal board
Safety Summary
The following are general safety precautions that are not related to any specific
procedure and therefore do not appear elsewhere in this technical manual.
These are recommended precautions that all personnel must understand and
apply during all phases of operation and maintenance.
KEEP AWAY FROM ANY LIVE CIRCUITS !
(Do not touch any circuits under operation!)
Operating personnel must at all times observe all safety regulations.
Do not replace components or make adjustments inside the unit with the high
voltage supply turned ON. Under certain conditions, dangerous potentials may
exist also, when the power breaker is in the OFF position, due to charges
To Next Page
Loading...