Consilium SRT - Chapter 2 Operation; Introduction Purpose; Controls and Indicators; Semi-Operative Controls

SRT X-BAND RADAR SYSTEMS
OPERATION
304202P003 2.1 Rev. C
CHAPTER 2
OPERATION
2.1 Introduction
2.1.1 Purpose
The present chapter provides the operating instructions, information and procedures required
in order to enable operating personnel to efficiently and effectively operate the SRT X-BAND
Radar System, for it to accomplish its designated tasks.
The Chapter is divided in:
Paragraph 2.2 Controls and Indicators
Paragraph 2.3 Semi-operative Controls
The Unit does not require personnel on steady watch conditions, but requires general
monitoring during normal operating situations. Since, the Unit has no operating controls,
paragraph 2.2 is not applicable. All semi-operative controls are located inside the unit.
2.2 Controls and Indicators
Since the Unit has no operating controls, this paragraph is not applicable.
2.3 Semi-operative Controls
The unit is fitted with some semi-operative controls, which are accessible, when the front
cover is open.
Table 2.3.1 - Semi-Operative Controls Location of TXRX Cabinet
Fig. Pos.
Code
(Ref. Assy)
Type Function
Figure 9.1.4 9 S1
(Electronics
Rack)
Interlock TXRX cover interlock switch for disabling the
High Voltage generation