Consilium SRT - Chapter 8: Installation; 8.1 Introduction and Handling

To Next Page

To Previous Page

SRT X-BAND RADAR SYSTEMS

INSTALLATION

304202P003 8.1 Rev. C

CHAPTER 8

INSTALLATION

X-Band Antenna Group including 6 or 9 12

feet Antenna and Pedestal with 12 / 25 kW

Transceiver up-mast

TABLE OF CONTENTS

CHAPTER 8 INSTALLATION..................................................................................................................

8.1 INTRODUCTION.............................................................................................................................

8.1.1 SHIPPING......................................................................................................................................

8.1.2 UNPACKING .................................................................................................................................

8.1.3 STORAGE......................................................................................................................................

8.1.4 HANDLING ...................................................................................................................................

8.2 SPECIFICATIONS ...........................................................................................................................

8.2.1 DIMENSIONS AND WEIGHTS (ALSO SEE OUTLINE DRAWINGS)

8.2.2 REQUIRED POWER ........................................................................................................................

8.2.3 ENVIRONMENTAL DATA...............................................................................................................

8.3 INSTALLATION .............................................................................................................................

8.3.1 INSTALLATION PRINCIPLES ..........................................................................................................

8.3.2 MECHANICAL INSTALLATION .......................................................................................................

8.3.2.1 UNIT (PEDESTAL + TRANSCEIVER)...........................................................................................

8.3.2.2 ANTENNA ................................................................................................................................

8.3.2.3 SAFETY SWITCH ......................................................................................................................

8.3.2.4 PERFORMANCE MONITOR ARM ( OPTIONAL )..........................................................................

8.3.3 ELECTRICAL INSTALLATION .........................................................................................................

8.3.3.1 MULTICORE CABLE .................................................................................................................

8.3.3.2 SAFETY SWITCH ......................................................................................................................

8.3.3.3 GROUNDING ............................................................................................................................

8.3.4 PRE SETUP PROCEDURES..............................................................................................................

8.3.4.1 SHIP POWER VOLTAGE ............................................................................................................

8.4 INSTALLATION FIGURES AND DRAWINGS .....................................................................................

8.5 ANNEX .........................................................................................................................................

8.5.1 MULTICORE CABLING AND TERMINATION PRINCIPLE..................................................................