User Manual
6
Chapter 4 Instrument Characteristics
4.1 Recording system: Thermal-array (8 dots/mm),you should not adjust anything Frequency
Response is up to 150Hz.
4.2 The device can record real time clear and exact three channel ECG waveform and remark
continually. The remark includes: lead sign, sensitivity, paper speed, filter state, etc.
4.3 Under automatic mode, just press the button once, it starts record procedure, which can
enhance your
work efficiency.
4.4 Soft keyboard control, more convenient for operation. TFT screen shows the working status,
more clear for observation.
4.5 Safety Class: Class I, Type CF.
4.6 The power supply includes both AC/DC. This device includes built-in lithium rechargeable
battery,
4.7 This instrument can record 150 pieces of ECG waveform and print 90 minutes continually
under the best DC state.
4.8 This instrument can store more than 1000 pieces patient’s data, more convenient for data
review and statistic.
4.9 The figure of whole device is elegant and gliding.
4.10 According to defense degree of deleterious fluid, this device belongs to common device.
4.11 According to the safe degree used under the condition with flammable anaesthesia gas
mixed with
air (or oxygen, nitrous oxide), this device belongs to the device which can’t be used under the
condition
with flammable anaesthesia gas mixed with air(or oxygen, nitrous oxide).
4.12 Digital signal processor for effective inhibition of baseline drift, interference, and the like.
4.13 The instrument has function with regular auto-measurement of ECG waveform parameter,
auto-analyze and auto-diagnostic, it will help to reduce doctor’s burden and improve working
efficiency.
4.14 According to the working mode class, this device belongs to non-continuous working
device.
4.15 Explanation of some symbols in this device:
～AC AC work mode
OFF Power supply is disconnected
ON Power supply is connected
Equipotential point
Places need to be noticed, please refer to user manual
To Next Page
Loading...
Need help?
General
