Contec IPC-PT/MV10 Series Hardware Manual

3. Each Component Function
24 IPC-PT/MV10 / IPC-PT/LS10 / HPC-HMV10 / HPC-HLS10 Hardware Manual
External Speaker Output Terminal
Connector: HSJ1456-010330 (HOSIDEN)
Table 3.13. External Speaker Terminal
Pin no.
1
2
3
Remarks
---
Speaker(Right)
Speaker(Left)
Signal
GND
Analog signal(R)
Analog signal(L)
1pin
2pin
3pin
GND
R Analog signal
L Analog signal
Applicable connector: Small jack of
φ
3.5 mm
Full-scale output level 1.0Vrms(Typ.)
Touch Panel
The PANECON-PC is equipped with an analog touch panel that enables keyboard-less, mouse-less
operations.
Refer to the software manual for details on how to use the touch panel.
Table 3.14. Touch panel specifications
Model IPC-PT/MV10, HPC-HMV10 series IPC-PT/LS10, HPC-HLS10 series
Detection method Analog resistive
Active area 211.2×158.4mm 246×184.5mm
Surface treatment No glare
Resolution 4096×4096 (emulated in 640×480 mode) 4096×4096 (emulated in 800×600 mode)
Operating force 50g±30g
Operating lifetime 1 million touches minimum
(as tested by mechanical touching under 300g of force at a rate of two presses per second)
Setting the SW2 to 4, JP5
1
2
3
4
5
6
7
8
SW4
ON
1
2
3
4
5
6
7
8
SW2
ON
1
234
SW3
ON
1
12
B
C
A
JP5
Figure 3.16. SW, JP on main board
Table 3.15. Internal Connectors and SW List
Silk Function Type Remarks
SW2 Setup of boot operation ESD108LT 8pin
SW3 User opening ESD104LT 4pin
SW4 RS-422A/485 mode setting ESD108LT 8pin
JP5 COM2 switching between RS-232C and
RS-422A/485
3pin×12

Contec IPC-PT/MV10 Series Specifications

General

Brand	Contec
Model	IPC-PT/MV10 Series
Category	Touch Panel
Language	English