Genus G1 MARK II Users Manual
UM3010-2
Debugging
The Debug Setup page allows an administrator to enable application and system debugging.
Configurable options:
• Enable/disable debugging • Max Debug Storage (bytes)
• Debug Level • Storage Limit Action
• Max Debug Time (hours)
Note: The default location for the debug file is \ramdisk\errors.txt
Debug Level
This setting defines the minimum level of messages that will be logged. This only affects
terminal applications that utilize the debug levels. Debug messages without levels are
always stored. The debug priority levels include (Low, Medium, High, Severe) to write to the
file.
Maximum Debug Time
This Sets up the maximum amount of time in hours (x number of hours) to allow debugging to
run. When the time is reached debugging is stopped. If set to zero (0 = infinite). If the
Terminal is rebooted at any time the debugging will stop.
Revision B 10-30-07 53
To Next Page
Loading...