Control Module Genus G1 Mark II - Programming Table (Code 39); Special Character Access via Barcode

Genus G1 MARK II Users Manual
UM3010-2
Programming Table (Code 39)
This table provides Code 39 barcode access to special characters that are not available on
the Genus terminal keypad. By using a digital barcode wand, these individual characters can
be entered into the network setup parameters prompted by the Terminal.
∗0∗ ∗1∗ ∗2∗ ∗3∗ ∗4∗
∗5∗ ∗6∗ ∗7∗ ∗8∗ ∗9∗
∗Α∗ ∗Β∗ ∗Χ∗ ∗∆∗ ∗Ε∗
∗Φ∗ ∗Γ∗ ∗Η∗ ∗Ι∗ ∗ϑ∗
∗Κ∗ ∗Λ∗ ∗Μ∗ ∗Ν∗ ∗Ο∗
∗Π∗ ∗Θ∗ ∗Ρ∗ ∗Σ∗ ∗Τ∗
∗Υ∗ ∗ς∗ ∗Ω∗ ∗Ξ∗ ∗Ψ∗
∗Ζ∗
∗α∗ ∗β∗ ∗χ∗ ∗δ∗ ∗ε∗
∗φ∗ ∗γ∗ ∗η∗ ∗ι∗ ∗ϕ∗
∗κ∗ ∗λ∗ ∗µ∗ ∗ν∗ ∗ο∗
∗π∗ ∗θ∗ ∗ρ∗ ∗σ∗ ∗τ∗
∗υ∗ ∗ϖ∗ ∗ω∗ ∗ξ∗ ∗ψ∗
∗ζ∗
Revision B 10-30-07 66