Genus G1 MARK II Users Manual
UM3010-2
Loading A Customer Defined Java Application
This application runs on the terminal and handles both a user interface and any backend
processing or communication. This is created by the user of the terminal, a value added
Reseller, or CMI.
tftp -i <ip address> PUT <myapp.jar> \flashdisk\App.jar
where <myapp.jar> is the local name of the user created Java application.
Important Note: The terminal will reboot after sending the file above.
See the Genus Software Development Kit (SDK) for more information on creating terminal
applications.
Loader Mode
This application is available as of version V2.02.04 of the Genus Terminal firmware and
provides access to terminal network settings when communication to the Terminal has been
compromised.
To access the Loader Mode put the Terminal into
offline mode by using the on line/off line setup switch
on the back of the terminal.
Press quickly to enter the Loader Mode when
the Loader Setup screen appears.
The Terminal retains the IP address that was
stored and will display this in Loader Mode.
If DHCP had been set the IP address would
display as all zeros in the octets.
Pressing will zero out the octets.
Use 0-9 and the or keys to
advance and return between octets.
Revision B 10-30-07 61
Loader G1
Control Module Inc.
Program: xxx-xxx
VX.XX.XX
Loader Setup
Press E to Continue
other key to Exit
Enter IP ADDRESS:
192.168.000.064
To Next Page
Loading...