Control Techniques M'Ax 406 User Manual

*
110 M’Ax User Guide
Issue Number: 4
Programming Instructions 21
Pulse reference inputs 79
Pulse reference selection and scaling 75
Q
Quick selection of the initially displayed parameter 23
R
Ramp selection 56
Read-write and read-only 19
Restoring the Drive to a default state 90
Restoring the Drive to the default state 27
RJ45 connectors 5
, 76
Routing the serial communications cables 87
S
Saving new parameter-values 26, 90
Scale factor 74
Security levels 42
Selecting a different option 27
Selecting a parameter to access 23
Selecting an advanced menu 43
Selection of PID-gains sets and PID buffers 96
Sending a motor-overload alarm to the system or motion
controller 4
Sequence for editing parameters 21
Sequencer functions 65
Serial Communications 86
Serial communications 74
Serial communications protocols and interfaces 86
Setting up PID gains for gain sequencing 96
Setting Up the Drive for Basic Applications 31
Setting up the programmable parameter 41
Setting up User Security 42
Signal connections for high-precision analog speed control in
Terminal mode 9
Signal connections for high-precision speed control by motion
controller supplying an analog speed reference 14
Signal connections for operation in Keypad mode 8
Signal connections for remote control by a system controller or
PLC supplying quadrature AB, F/D signals or directional
pulse inputs 11
Signal connections for remote control by motion controller
communicating by A technology 16
Signal connections for serial communications 12
Signal connections for standard-precision analog speed control
in Terminal mode 10
Signal connections for standard-precision speed control by
motion controller supplying an analog speed reference 15
Signal Connectors 76
signal terminals 6
Signal-ground connections 7
SIM ENC 80
SLM 82
SLM-and-user back-up supply 17
* 1
Software parameters 19
S-parameters 108
Specifying a different initially displayed parameter 41
Specifying a parameter 88
Specifying an address 87
Specifying shaft stiffness and load inertia 93
Speed reference selection 52
Speed-loop parameters 92
Speed-loop PID gains 59
Status and diagnostic information 73
Status indications 84
Status LEDs 19
, 84
Status mode 22
Stiffness angle 93
Storage and Transfer of Parameter Value 107
Storing new parameter-values 90
Summary of security operations 42
Summary of the keypad functions 21
T
Temperature monitoring 68
Thermal protection of the motor 2
Torque control 61
Trip codes 85
Trip log 73
Types of back-up supplies 17
Types of parameter 19
U
Unlocking Standard Security 42
Unlocking User Security 42
User Interface 18
Using the auxiliary back-up supply 102

Control Techniques M'Ax 406 Specifications

General

Brand	Control Techniques
Model	M'Ax 406
Category	Servo Drives
Language	English