JOLLY Operator’s manual 27
GB
TRANSPORT, STORAGE AND HANDLING
Conditions for transporting the machine
The tyre changer must be transported in its original packing and maintained in the
position shown on the outer packing.
- Machine packing dimensions
• width 7 6 cm 20” version cm 92
• depth 98 cm 20” version cm 134
• height 102 cm 20” version cm 110;
- Shipping weight: 200 kg (T.I. 210 kg) 20”version kg 237 (T.I. 247 kg)
Ambient conditions for storage and transport
Temperature range from -25° to +55°
WARNING
Do not stack other goods on top of the packing or damage may result.
Handling
To move the packed machine insert the forks of a pallet truck in the channels in the
base of the pallet (fig.1).
Before moving the machine refer to the chapter HOISTING AND MOVING
ATTENTION
Keep the packing material intact for possible future transport of the machine.
UNPACKING / ASSEMBLY
WARNING
Take the utmost care when unpacking, assembling, and setting up the machine as
described in this heading.
Failure to observe these instructions can lead to damage to the machine and injury
to the operator or other persons.
- Remove the upper part of the packing and make sure that the machine has not suf-
fered damage in transit; identify the points at which the machine is anchored to the
pallet (fig.1).
- The machine comprises three main sections (fig.1):
A cabinet
B tower
C air tank (T.I. version only)
- Once you have removed the tower (B) it is advisable to set it in a horizontal position
to avoid the risk of it falling and getting damaged.
To Next Page
