34 JOLLY Operator’s manual
Key to danger warning decals.
Risk of crushing.
Never place any part of the body between the bead breaker shoe,
the rim and the rim support.
When securing the rim on the table top, never place your hands
between the sliding clamp and the rim.
BEAD BREAKING
ATTENTION
During this stage of operations noise levels may be up to 85 dB(A). We recommend
that operators wear hearing protectors.
Deciding from which side of the wheel the tyre must be demounted
Fig.8
A Narrow side - Side for mounting the tyre
B Rim channel
C Wheel
D Wider side - You cannot mount tyres from this side
The two sides may be almost identical, but only the narrow side serves for tyre
mounting and demounting
Identify the side for tyre mounting and make sure that this side is facing upward when
you install the tyre on the table top (i.e. facing toward the mount/demount head)
Special instructions
Alloy wheels
Some alloy wheels on the market have minimal rim channels or are even completely
without rim channels (these wheels are not DOT approved).
Fig.9
A No rim channel
To Next Page
Loading...
