JOLLY Operator’s manual 41
GB
The FRL unit withstands a maximum input pressure of 18 bar and has a regulation range from
0.5 to 10 bar. The setting can be modified by pulling the knob to the OUT position and turning
it; after adjusting, return the knob to the locked position by pushing it down (fig.32a).
The lubricating flow-rate is adjusted by turning the screw on the element “L”, (fig.32b);
normally the unit is preset at a pressure of 10 Bar, with lubricant having viscosity SAE20,
so that one drop of lubricant is dispensed every 4 times the bead-breaker is operated
(check through the transparent cup).
DANGER
Before carrying out any maintenance operation or topping up with lubricant, discon-
nect the machine from the compressed air supply line.
Check the lubricant level periodically through the windows provided and top up as
shown in fig.32c. Top up only with SAE20 non detergent oil to a total quantity of 50 cc.
The FR filter regulator unit is equipped with an automatic system for drainage of the con-
densation water, so in normal conditions it does not require any particular maintenance.
However, the water may be drained by hand at any time (fig.32d).
Normally it is not necessary to remove the cups, but this may be necessary after long
periods out of use; if the cup cannot be removed with the hands only, use the spanner
provided (fig.32e).
Clean with dry cloth. Avoid contact with solvents.
ATTENTION
Keep the work area clean.
Do not clean the machine with compressed air or jets of water.
When cleaning the area avoid raising dust as far as possible.
ENVIRONMENTAL INFORMATION
Following disposal procedure shall be exclusively applied to the machines having the
crossed-out bin symbol on their data plate.
This product may contain substances that can be hazardous to the environment or to
human health if it is not disposed of properly.
We therefore provide you with the following information to prevent releases of these
substances and to improve the use of natural resources.
Electrical and electronic equipments should never be disposed of in the usual munici-
pal waste but must be separately collected for their proper treatment.
The crossed-out bin symbol, placed on the product and in this page, remind you of the
need to dispose of properly the product at the end of its life.
In this way it is possible to prevent that a not specific treatment of the substances con-
tained in these products, or their improper use, or improper use of their parts may be
hazardous to the environment or to human health. Furthermore this helps to recover,
recycle and reuse many of the materials used in these products.
To Next Page
Loading...
