JOLLY Operator’s manual 37
GB
INFLATION
WARNING
Tyre inflation is a dangerous operation. Always inflate tyres in the strictest observan-
ce of the following instructions.
ATTENTION
During this stage of operations noise levels of 85 dB(A) may be present. We recom-
mend that the operator wears hearing protectors.
WARNING
During the bead insertion and inflation procedure, safety goggles and ear defen-
ders must be worn.
DANGER
The machine, even if it limits pressure, does not provide sufficient protection again-
st exploding tyres during inflation.
Failure to observe the following instructions will make tyre inflation extremely dan-
gerous.
DANGER
NEVER exceed the maximum pressure stipulated by the tyre manufacturer. If they
are inflated beyond this limit tyres are liable to explode. KEEP THE HANDS AND
BODY WELL CLEAR OF THE TYRE DURING INFLATION. Make sure you are well
concentrated during this stage of operations and make frequent checks on the tyre
pressure to avoid the risk of excess inflation. Exploding tyres can cause serious
injury or death.
Inflation
- Release the wheel from the table top jaws.
- Connect the Doyfe inflator chuck on the air hose to the valve stem.
- Inflate the tyre with small blasts of air (fig. 29). Never exceed the maximum pressure
specified by the tyre manufacturer.
Inflating tubeless tyres (T.I. version)
WARNING
Before carrying out the operations described below, always make certain that there
is no dirt, dust or other foreign matter on the jaws near the air outlet holes.
- Make sure that the wheel is secured to the table top with inside clamping.
- Connect the Doyfe inflator chuck on the air hose to the valve stem.
- Hold the tyre with your hands and lift it until there is a slight gap between the lower
bead and bottom edge of the rim in order to close the upper bead and the top of the
rim.
To Next Page
Loading...
