Corghi ProLine 124 - Page 58

138 ProLine 124-221-321-324 Operator manual
with 4 M6x10 screws (Fig. 59)
- Install the accessory support on the back of
the Tyre changer, no. 2 M8x25 screws (fig.60)
- Adjust the centring as in fig.61, install the
cone and centre it with the turntable and lock
the screw 1 fig.62. Then fasten the 4 screws
of the fixed base 2 (fig.62) and tighten nut 3
- Install the Y-connection (fig.63)
10.2.b. Technical data
HSU24
- Pneumatic cylinder force (a 8 bar) 4000 N
฀ ............................................. 1000 mm
฀฀ ............................................. 1200 mm
฀฀฀฀฀ .............. 360 mm
฀฀฀฀฀ .............. 100 mm
฀฀฀ ...................................... 320 mm
59
60
61
62
63
58