8 2 GENERAL INFORMATION AND SPECIFICATIONS
i) Quick mounting brackets
• Tester can be removed from the machine easily from the front side by using these brackets.
j) Clamp signal
• This tester can control external solenoid valve to drive air cylinder. Use of this feature allows
building a simple and low cost machine system.
k) Fitness to overseas use
• The power inlet can accept 100 to 240 VAC ±10 % at 50/60 Hz single-phased power supply,
100VA max. The standard power cord supplied with the leak tester is rated for 100 to 120.
Special power cord for 125 to 240 VAC is available upon request.
l) Data storage in flash memory
• There is no need of battery replacement because all the test parameters are stored in flash
memory.
m) Channel copy
• Test parameters of a channel can be copied to the another. This makes multi-channel program
easier.
n) Exhaust interference prevention
• When using several leak testers to measure different cavities on the same part simultaneously, this
prevents jumps in the leak tester readout during the exhaust of one of the other testers.
To Next Page
