6 PARTS IDENTIFICATION AND FUNCTIONS 35
6.1.2 Keyboard
A TIME/LIMIT key : Used to program or view the stage timers and the limits.
(See Sections 7.12 and 7.13. → )
B SHIFT key : Enables the function marked in the upper part of each typeface., SFt appears on the leak
rate indicator when this key is pressed.
C RIGHT► Key : Used to switch modes or to move the cursor from one position to the next.
D ◄LEFT Key : Used to switch modes or to move the cursor from one position to the next.
E CHG HOLD key : Used to pressurize ( or evacuate for vacuum testers) the master and tested part
continuously. (See Section 7.15 → )
F MAN/REM key : Used to switch the leak tester mode to remote or manual. (See Section 7.7 → )
G CHANNEL ▲ UP key : Used to increments a value or change the channel. (See Section 7.9 → )
H CAL./COMP. key : Used to calibrate leak tester (calculation of leak coefficient K(Ve).
(See Section 8 → and Section 9 → )
I UNIT DOWN ▼ key : Used to decrements a value or to change leak units. (See Section 7.14 → )
J ENTER key : Used to complete programming or mode selection.
K STOP key : Used to stops a leak test and mode operations. (See Section 7.8 → )
L START key : Used to starts a leak test. (See Section 7.8 → )
To Next Page
Loading...
Need help?
General
