Cosmos PS-7 - Page 19

19
DC-ITD-PS7MAN01.A www.dodtec.com
JAN 2019 815-788-5200
PS-7 Manual
Proceed with operation in the following manner:
1. Verify that the power supply voltage (the voltage between the P and N of the terminal block) is 24 VDC
10%.
2. Switch the base unit power ON.
Warning
• Verify that the power supply voltage is 24 V DC 10%.
• Before operating the Gas Detector, verify that the sensor unit correctly displays the
type of gas to be detected and the full-scale value.
Warning
• Before Turning the power on, check that all connections are correct. Refer to 6.2
Wiring Instructions and the separate delivery specifications if available.