Chapter 3 – Contents of This Package
The following components are included with the standard Gas Detector unit. Ensure that all components are
present before attempting to use the unit. Every effort is made to ensure that the unit is packed correctly, but
if any components are damaged or missing, contact your local authorized distributor.
*1 2 sticks are provided with each system.
NOTE:
1. The sensor unit is not bundled with the Gas Detector and must be purchased separately.
2. When it is with DeviceNet unit, the contents are as described in the DeviceNet Unit Instruction manual
IMPORTANT NOTICE - If using the PS-7 for absorbent / corrosive gases such as HCl, HF, Cl2, HBr, etc. You
must remove the internal filter and install #2-800-013 OR #60009 Corrosive Filter at the end of the sample
line.
Teflon FEP sample tubing must be used in conjunction with the corrosive filter when monitoring for corrosive
/ absorbent gases. 1/4 OD x 3/16” ID
See Chart on next page
To Next Page
Loading...
