Cosmos PS-7 - 2.3 Changing Setting Values

53
DC-ITD-PS7MAN01.A www.dodtec.com
JAN 2019 815-788-5200
PS-7 Manual
7. Remove the calibration gas and confirm that no alarm is displayed( ALARM 1 , ALARM 2 is not shown).
Then, restore to the normal mode by switching the maintenance switch to the center.
2.3 Changing Setting Values
Some of the setting values of the unit can be changed. Those that can be changed are listed in the table
below. The method for changing them is explained here.
1. Release the password lock. (Refer to 1.2 Releasing the Password Lock.)
2. Press the UP/DOWN switch (“” or “”)
until the setting you wish to change ( “LCD
Screen Indication” in the table below ) is
displayed at the bottom right of the LCD
displays.
3. Then press the special command switch, and
the setting to be changed ( “LCD Screen
Indication” in the table below ) and “—“ will
flash alternately.
4. Change the value by using the UP/DOWN switches (“” or “”). When you are done, press the
special command switch again, and the alternating display in the bottom right corner of the LCD
display will become constant. The process is now finished.