COX CXO300 - Page 67

6.0 MAINTENANCE 67
CXO300 OWNER’S MANUAL
4 Prepare a new oil filter and check that a seal is present on the sealing side of the filter.
5 Using the lint-free cloth, wipe a light layer of fresh oil over the seal’s face.
6 Start the oil filter on the threaded spigot, then turn until the seal contacts the base. Tighten the filter a
further 3/4 to one turn by hand.
7 Wipe clean any oil residue in the work area and refit the upper cowling and close the latches unless
performing other work
 NOTE
Cox Powertrain recommends that only Cox approved oil filters are used on the outboard.