GENERAL INFORMATION GI-6
SPARE PARTS
If parts have to be replaced, use original CPI spare parts only.
REASSEMBLY
If reassembling engine parts, precisely obey the instructions
regarding defaults of tightening torques and other settings. The
following parts always have to be replaced prior to reassembly.
1. Oil retainers
2. Washers
3. O-rings
4. Lock washers
5. Split cotter pins
6. Plastic nuts
Depending on the mounting place the following should be
carried out:
1. Applying sealant to washers.
2. Oiling of moveable parts.
3. Oil or lubricating grease must be applied to defined spots
(e.g. oil retainers) prior to assembling.
ELECTRICAL EQUIPMENT
1. Always disconnect the cable from the battery’s (-) negative
terminal first.
2. Never pull the cable when disconnecting connections.
Always remove plugs by pulling the plug.
3. Snap-in connections are properly made when you can hear
a click noise.
4. Sensors and relays have to be handled carefully. Do not
drop them and avoid contact with other parts.
RUBBER PARTS, RUBBER-SHEATED CABLES, AND
RUBBER TUBES
Pay attention not to wet rubber parts, rubber-sheated
cables, and rubber rubber tubes with petrol or oil.
To Next Page
