GENERAL INFORMATION GI-7
MAINTAINING THE ELECTRICAL SYSTEM
1. Prior to maintaining the electrical system, the ignition has
to be switched off and the battery ground cable has to be
disconnected.
2. To avoid slack, wiring harnesses have to be fixed with
cable clamps or cable fastening ribbons. However, allow a
little play to all wiring harnesses, which are routed to the
engine or other vibrating vehicle parts. This play must be
in such a way that the wiring harnesses do not contact
adjacent parts due to engine vibrations.
3. If any part of a wiring harness is routed along an edge or
corner of a vehicle part, or if it has contact to that edge or
corner, that section of the harness has to be wrapped round
with tape or the like in order to protect it against damage.
4. When mounting or reinstalling vehicle parts, pay attention
not to pinch or damage any of the wiring harnesses.
To Next Page
